Making re-usable mold for bases
Posted: Fri Aug 30, 2013 12:08 pm
Hi guys!
I am planning on making some molds for base inserts. I figure it will save some time on basing in the long run. I have a few questions.
1) Should I use a 2 part silicone rubber (liguid) a silicone putty or even instant mold?
2) Should I cast in resin or use an epoxy putty?
I figure a 1 piece mold will be ok. Just pour the resin or squish the putty into the open top. I think 4 or 5 inserts for 30mm bases should give enough variety once grass and moss is added to different places.
Any advice guys?
I am planning on making some molds for base inserts. I figure it will save some time on basing in the long run. I have a few questions.
1) Should I use a 2 part silicone rubber (liguid) a silicone putty or even instant mold?
2) Should I cast in resin or use an epoxy putty?
I figure a 1 piece mold will be ok. Just pour the resin or squish the putty into the open top. I think 4 or 5 inserts for 30mm bases should give enough variety once grass and moss is added to different places.
Any advice guys?